| Featured Products this Week |
|
|
| 70 kW Electric Axle for 4.5T-7T Light Truck Applications | |
Electric Axle
from Brogen EV Solution
|
| The 40QES from Brogen EV Solution is an Electric Axle that offers a reduced total weight by 20% compared to traditional structures, with a similar reduction in volume. It delivers a continuous output power of 70 kW, a peak output power of 150 kW, and has an efficiency of over 93%. This e-axle provides a torque of 150 Nm and has a speed of up to 12000/16000 rpm. It has a relatively lower number of components compared to conventional designs. |
| |
Download Datasheet
Product Details | |
|
|
|
| Ferrite Core Push-Pull Transformer for Power Supply Applications | |
Power Transformer
from TDK Corporation
|
| The B82805A0773A250 from TDK Corporation is a Ferrite Core Push-Pull Transformer IC that is ideal for switch-mode power supplies, isolated interface power supplies, industrial automation, and process control applications. This transformer has an inductance of 77 µH and a turns ratio of 1:1:1:1:1:1. It provides an isolation voltage of 500 V (RMS). This RoHS-compliant push-pull transformer has a Ferrite core with copper wire windings on both the primary and secondary sides. |
| |
Download Datasheet
Product Details | |
|
|
|
| 1320 A Fluxgate AC/DC Current Transducer | |
Current Transducer
from Danisense
|
| The DM1200UB-10V from Danisense is an AC/DC Current Transducer that has been designed for DC and AC current measurements up to 1320 A. This current transducer requires an input current of less than 1320 A and a supply voltage of 10 V. It can continuously measure current levels of 1320 A while maintaining a linearity error of less than 15 ppm. This RoHS-compliant current transducer is based on Dansense’s ultra-stable closed-loop flux gate technology. |
| |
Download Datasheet
Product Details | |
|
|
|
| Single-Cell Li-ion Battery Protection IC for Wearable Applications | |
Battery Management IC
from Nisshinbo Micro Devices
|
| The NB7141ZA Series from Nisshinbo Micro Devices is a Single-Cell Li-ion Battery Protection IC ideal for wearable/hearable devices, smartphones, and handheld data terminal applications. It requires an input voltage of 1.5-5 V. This protection IC consists of logic circuits, an oscillator, standby/WDT circuit, counter, level shifter, error amplifiers, and other active/passive elements. It includes low voltage and high accuracy over-current detection scheme. |
| |
Download Datasheet
Product Details | |
|
|
|
| 45 W Compact AC-DC Converter for Cost-Sensitive Applications | |
AC to DC Converter
from Traco Power
|
| The TXO 45-112-J from Traco Power is a Compact AC-DC Converter that converts an AC input voltage of 85 - 264 V to a DC output voltage of 12 V. This converter delivers an output power of up to 45 W and has an efficiency of 85%. It provides a switching frequency of 65 kHz. This converter integrates an internal EN55032 class B filter enhancing its electromagnetic compatibility. It benefits from safety mechanisms such as short circuits, overvoltage, and overload protection. |
| |
Download Datasheet
Product Details | |
|
|
|
| 12 V Buck DC-DC Converter for Constant Voltage Supply Applications | |
DC to DC Converter
from AiT Semiconductor
|
| The A7431MP8R from AiT Semiconductor is a Buck DC-DC Converter that converts an input voltage of 10 - 36 V to an output voltage of up to 12 V. It has a switching frequency of 125 kHz and an efficiency of up to 91%. This converter integrates low-equivalent series resistance (ESR) ceramic capacitors to provide stability and allow low-profile designs. It offers constant current control without an additional current sensing resistor thereby improving efficiency and lowering cost. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
| 6 V P-Channel Junction Field Effect Transistor | |
Junction Field Effect Transistor (JFET)
from Microchip Technology
|
| The 2N5115E3 from Microchip Technology is a P-Channel Junction Field Effect Transistor. It has a gate-source voltage of 6 V and a drain-source on-resistance of 100 ohms. This MIL-PRF-19500-qualified junction field effect transistor (JFET) has a power dissipation of less than 0.5 W. It is military-screened to JANTXV standard equivalent for high-reliability applications. This JFET is available in a through-hole package that measures 4.95 x 24.38 mm. |
| |
Download Datasheet
Product Details | |
|
|
|
| 1800 V Field Stop Trench IGBT for Induction Heating Applications | |
IGBT
from ROHM Semiconductor
|
| The MG7405WZ from ROHM Semiconductor is a Field Stop Trench IGBT that is ideal for voltage-resonance inverter and induction heating applications. It has a collector-emitter breakdown voltage of over 1800 V, a gate threshold voltage of 6 V, and a saturated collector-emitter voltage of 2.2 V. This IGBT has a collector current of 40 A and a gate-emitter leakage current of ±200 nA. It utilizes trench light punch-through (LPT) technology. This IGBT offers high-speed switching. |
| |
Download Datasheet
Product Details | |
|
|
|
| 1200 V Silicon Carbide Power MOSFET for Renewable Energy Applications | |
MOSFET
from Alpha & Omega Semiconductor
|
| The AOK065V120X2 from Alpha & Omega Semiconductor (AOS) is a Silicon Carbide Power MOSFET that is ideal for industrial and renewable energy applications such as EV chargers, solar inverters, UPS, SMPS, and motor drive applications. It has a drain-source breakdown voltage of over 1200 V, a gate threshold voltage of 2.8 V, and a drain-source on-resistance of less than 65 milli-ohms. This power MOSFET has a continuous drain current of up to 40.3 A. |
| |
Download Datasheet
Product Details | |
|
|
|
| Slew Rate-Controlled High-Side Power Switch for Cellular Applications | |
Power Switch IC
from Vishay
|
| The SiP4282DVP3-T1GE3 from Vishay is a Slew Rate-Controlled High Side Switch that is ideal for cellular telephones, digital still cameras, personal digital assistants (PDA), hot-swap supplies, notebook computers, personal communication devices, and portable instruments applications. It requires an input voltage of 1.8 - 5.5 V and provides an output current of 1.2 A. This power switch integrates a P- Channel MOSFET with low on-resistance to allow larger currents. |
| |
Download Datasheet
Product Details | |
|
|
|
| 100 V Enhancement Mode GaN-on-Si Power Transistor | |
GaN Power Transistor
from Innoscience
|
| The INN100EQ025A from Innoscience is an Enhancement Mode GaN-on-Silicon HEMT Power Transistor that is ideal for high-frequency DC-DC converters, battery management system (BMS) protection, RF envelope tracking, PC chargers, mobile power banks, and motor driver applications. It has a drain-source breakdown voltage of over 100 V, a gate threshold voltage of 1.1 V, and a drain-source on-resistance of less than 2.8 milli-ohms. |
| |
Download Datasheet
Product Details | |
|
|
|
| Automotive-Qualified PNP Transistor for Charging Applications | |
Bipolar Junction Transistor
from Nexperia
|
| The PBSS5350PAS-Q from Nexperia is an Automotive-Qualified PNP Transistor designed to offer reduced printed circuit board (PCB) requirements. It has a collector-emitter breakdown voltage of over -50 V, an emitter-base voltage of up to -5 V, and a saturated collector-emitter voltage of less than -90 mV. This transistor has a continuous collector current of up to -3 A and a power dissipation of less than 0.5 W. It delivers high efficiency, which leads to a lower heat dissipation. |
| |
Download Datasheet
Product Details | |
|
|
| Sponsored by London EV Show 2024 | | London EV Show 2024 | | Get ready for the London EV Show 2024, where the latest electric vehicles and cutting-edge mobility solutions take center stage, showcasing the future of sustainable transportation.Click here to learn more. | | | |
|
|
| 1200 V Non-Punch-Through Power IGBT for SMPS Applications | |
IGBT
from Microchip Technology
|
| The APT100GT120JR from Microchip Technology is a Non-Punch-Through Power IGBT that has been designed to provide superior ruggedness and very fast switching speed. It has a collector-emitter breakdown voltage of over 1200 V and a gate threshold voltage of 5.5 V. This IGBT has a continuous collector current of up to 123 A and a peak collector current of less than 200 A. It belongs to a new generation of high-voltage power IGBTs. |
| |
Download Datasheet
Product Details | |
|
|
|
| 1:1:1:1:1.1 Flexible Transformer for DC-DC Converter Applications | |
Power Transformer
from Wurth Elektronik
|
| The 749196218 from Wurth Elektronik is a Flexible Transformer that is ideal for flyback converters, forward converters, push-pull converters, and step-up/step-down converters (SEPIC) applications. It has an inductance of 21.6 µH and a turns ratio of 1:1:1:1:1.1. This transformer has a current rating of 0.8 A and a DC resistance of less than 200 milli-ohms. It consists of six identical windings with low leakage inductance and offers an isolation voltage of up to 1500 V (AC). |
| |
Download Datasheet
Product Details | |
|
|
|
| 400 V Logic-Level Triac for Automated Placement Applications | |
Triac
from Fagor Electronica
|
| The FT0807DG00TR from Fagor Electronica is a Logic-Level Triac that has been designed for automated placements. It has a break-over voltage of 400 V and a break-over current of 84 A. This WEEE-compliant triac has a gate trigger voltage of up to 1.3 V and a gate trigger current of less than 5 mA. It has glass passivated die junctions and ensures low forward voltage drop. This RoHS-compliant triac has excellent thermal resistance. |
| |
Download Datasheet
Product Details | |
|
|
|
| 100 A EV Power Fuse for High-Power Battery Charging Applications | |
EV Fuse
from Eaton
|
| The XEV20-100-S from Eaton is an Electric Vehicle Power Fuse that has been designed for high-power battery charging and management systems. It has a voltage rating of 500 V and a current rating of 100 A. This RoHS-compliant fuse link can handle a breaking current surge of 20 kA. It is ten times faster in opening under high fault current conditions and helps assure reliable protection of circuits and components. |
| |
Download Datasheet
Product Details | |
|
|
|
| 185 W Monocrystalline Solar Panel | |
Solar Panels
from Australian Solar
|
| The ASM 185M from Australian Solar is a Monocrystalline Solar Panel that consists of 72 cells. It delivers an output power of 185 W and has an efficiency of 16.75%. This solar panel has a voltage rating of 38.16 V and a current rating of 5.09 A. This solar module includes a high transmission tempered glass with antireflective (AR) coating to improve efficiency. It is enclosed in an IP-65 rated junction box with 3 bypass diodes to further increase durability. |
| |
Download Datasheet
Product Details | |
|
|
|
| Automotive-Qualified Power-Film Capacitor | |
Power Capacitor
from TDK Corporation
|
| The B25654A5207K001 from TDK Corporation is an Automotive-Qualified Power-Film Capacitor that has been designed to offer scalability and modularity for different power levels and densities. It has a capacitance of 200 µF and a capacitance tolerance of ±10%. This AEC-Q200 Revision E-qualified capacitor has a voltage rating of 500 V (DC) and an equivalent series resistance (ESR) of 1.13 milli-ohms. It consists of a Polypropylene dielectric. |
| |
Download Datasheet
Product Details | |
|
|
| Sponsored by London EV Show 2024 | | |
|
|
| 10 V Single-Phase True RMS AC Current Transducer | |
Current Transducer
from Shenzhen Sensor Electronic Technology
|
| The CE-IJ03A-SK-0.5 from Shenzhen Sensor Electronic Technology is a Single-Phase True RMS AC Current Transducer that is ideal for real-time signal detection and monitoring applications. It requires a supply voltage (DC) of 12 - 24 V. This transducer provides an output voltage of up to 10 V and an output current of 0 - 20 mA. It features high accuracy and low drift, providing consistent performance over time. This transducer offers pressure resistance among the input. |
| |
Download Datasheet
Product Details | |
|
|
|
| 20 A Single-Phase Dual-Stage Filter | |
EMI / EMC Filter
from Cosel
|
| The NBM-20-471 from Cosel is a Single-Phase Dual Stage Filter. It has an AC/DC voltage rating of 250 V and a current rating of 20 A. This filter has a leakage current of less than 100 µA. It operates over a temperature range from -40°C to +85°C. This UL1283-approved filter has a low leakage current to enhance both performance and safety in sensitive electronic systems. This RoHS-compliant filter is available in a DIN rail-mount package that measures 53 x 41 x 92 mm. |
| |
Download Datasheet
Product Details | |
|
